Gravity Analog Isolator

Title Default Title
Qty:

Description

  • Gravity Analog Isolator
  • Converts analog output from Gravity pH, ORP, or D.O. meter to PWM and voltage signal
  • Comes with four standoffs and screws
  • Designed to work exclusively with the Gravity line
  • Voltage input: 3.0 V - 5.0 V
  • Connector: Header pins

The Gravity Analog Isolator is designed to work exclusively with the Gravity line of low-cost embedded meters. These isolators remove all electrical interference coming from other probes or pumps in the same water you are testing. It converts the analog output from a Gravity pH, Gravity ORP, or Gravity D.O. meter to both, a PWM and a voltage signal.

The PWM signal can then be easily converted back to a noise-free reading. Because this isolator uses PWM, it can be connected to a micro-controller that does not have an ADC. The voltage signal converts the sensor value into 0 - 3 Volts, good for a micro-controller that does have an ADC.

Please note: A Raspberry Pi cannot accurately read PWM or analog voltage without a 3rd party hat.

  • 1x Gravity Analog Isolator

Size

  • Carrier Board: 42 x 32 mm / 2.2 x 1.2 inch

PDF File

  • Data output: 10.6 KHz PWM | 0-3 Volts
  • Voltage input: 3.0 - 5.0 V
  • Connector: Header pins
  • Current consumption: 5 V - 23 mA | 3.3V - 15.7 mA
  • Weight: 13 g